Owner`s manual

5.25 Z

The Z command logically connects the console terminal to

another node on the XMI. Characters typed at the console

terminal following a Z command are passed to the target

node. All output from the target node is displayed on the

console terminal.

Examples

! Connect from the boot processor at

>>> Z 6 ! node 1 to CPU at node 6.

?0033 Z connection successfully started.

6>> ! Prompt indicates the new processor node no.

6>> D/P 0 12345678 ! Deposits data 12345678 to

! physical address 0.

6>> ^P ! End connection to CPU at node 6.

?0031 Z connection terminated by ^P.

>>> ! Prompt indicates you are in console

! mode on the boot processor.

>>> E/P 0

P 00000000 12345678 ! Examines physical address 0; shows data

! 12345678 was successfully deposited.

>>>

>>> Z /BI:6 E ! Connect to VAXBI node 6 through DWMBB in

! XMI slot E.

?0033 Z connection successfully started.

6>>

Table 5–18: Z Command Qualiﬁers

Qualiﬁer Meaning

/B[I]:<VAXBI-node> Speciﬁes connection to the VAXBI at node number indi-

cated by <VAXBI-node>.

<XMI-node> Speciﬁes connection to the XMI at node number indi-

cated by <XMI-node>.

5–68 VAX 6000 Series Owner’s Manual