Owner`s manual

5.24 UPDATE

The UPDATE command copies the contents of the boot

processor’s EEPROM to the EEPROM of the speciﬁed

secondary processor. The control panel’s lower key switch

must be in the Update position to use UPDATE.

Examples

! Lower key switch must be set to

! Update; upper switch to Enable.

>>> UPDATE 2 ! Update the processor at node 2.

>>> ! There is a pause while this

! command executes. When the

! console prompt returns, update

! is complete.

>>> UPDATE ALL ! Update all the secondary

>>> ! processors. There is a pause

! while this command executes.

! When the console prompt returns,

! update is complete.

>>> UPDATE 1

?0064 Operation only applies to secondary processors.

! The module at node 1 is not a

! secondary processor.

>>> UPD E ! Update the module at node E.

?004E Specified node is not a processor.

! System error message indicates

! that node E houses a memory or

! adapter module.

5–66 VAX 6000 Series Owner’s Manual