Owner`s manual

5.21 STOP

The STOP command halts a speciﬁed XMI (or optional

VAXBI) node. If the target node is a processor, the processor

enters console mode.

Examples

>>> STOP 2 ! Stops the processor at node 2 on the XMI.

>>> STOP E ! Stops the adapter at node E on the

! XMI. If the adapter at node E is a

! DWMBB/A, then all nodes on the

! VAXBI connected through node E are

! also stopped.

>>> STOP/BI:6 E ! Stops the adapter at node 6 on the

! VAXBI accessible through the

! DWMBB/A at node E.

>>> STO/B:6 E ! Same as above command.

Table 5–16: STOP Command Qualiﬁers

Qualiﬁer Meaning

/B[I]:<node> Speciﬁes a VAXBI node. Causes a VAXBI stop of the node at <node>

on the speciﬁed VAXBI.

<XMI-node> Speciﬁes an XMI node. Stops the processor or DWMBB/A at the

given node number.

5–60 VAX 6000 Series Owner’s Manual