Owner`s manual

This section describes the following SET commands:
• SET BOOT
• SET CPU
• SET LANGUAGE
• SET MEMORY
• SET TERMINAL
If you issue a set command and the control panel’s lower key switch is not
in the Update position, you may receive the following error message:
?0040 Key switch must be at "Update" to update EEPROM.
Despite the error message, the change completes and remains until the
primary processor or system is reset.
Whenever you issue a SET command, the console program tries to pass the
current values of all parameters that can be set to all system processors.
This requires that all system processors be in console mode. You receive an
error message if any processor is still running. Processors not in console
mode are not updated. Use the STOP command to stop each processor, or
issue an INITIALIZE command to stop all processors. (See Section 5.21
and Section 5.14.)
When you issue a system reset, the system checks the validity of the
systemwide parameters on each node and sends an error message to you if
the settings on any node do not match those on the current boot processor
or are corrupted.
Console 5–43