Owner`s manual

5.18 SET Commands
SET commands allow you to change the configuration
parameters on the boot device, primary processor, memory,
and terminal, and to modify the output of the error
messages. To store the new parameters in the processor’s
EEPROM, the control panel’s lower key switch must be
in the Update position. Some SET commands take effect
immediately, but the changes will be lost at the next node
or system reset if the EEPROM is not updated.
Figure 5–4: Lower Key Switch in Update Position
Update
Halt
Auto Start
0
msb-0171A-91
FRONT
5–42 VAX 6000 Series Owner’s Manual