Vax V-022 D4 mm.qxd 9/9/05 4:19 PM Page 1 Vax Careline: 0870 6061248 www.vax.co.uk CARPET WASHER Vax Model Number: V-022 Instruction Manual Please read carefully before using this cleaner. Always fully extend the mains cable before use.
Vax V-022 D4 mm.qxd 9/9/05 4:19 PM Page 2 Parts Overview 1. Diagram 16 15 17 1 18 14 19 10 2 3 13 4 20 5 6 11 9 12 8 7 Fig.
Vax V-022 D4 mm.qxd 9/9/05 4:19 PM Page 3 Safety Information 2. Safety Information FOR HOUSEHOLD USE ONLY. When using the carpet washer, basic safety precautions should always be observed, including the following: 1. 2. 3. 4. 5. 6. 7. 8. 9. 10. 11. 12. 13. 14. 15. 16. Only use the vacuum cleaner indoors on dry surfaces. Turn off the carpet washer controls before connecting to or disconnecting from the mains supply.
Vax V-022 D4 mm.qxd 9/9/05 4:19 PM Page 4 Use & Function/Preparing the Carpet 3. Use & Function Assembling the Carpet Washer 4. Place the clean water tank into the cleaner until it clicks into place (Fig.3/4). IMPORTANT: Always unplug the carpet washer from the electrical outlet before assembling or removing the accessories. 1. Stand the base in an upright position. Push the mid-section on to the base by aligning the tabs on the backside of the base (Fig.3/1).
Vax V-022 D4 mm.qxd 9/9/05 4:19 PM Page 5 Preparing the Carpet/How to Operate 8. Before cleaning, determine where to start and end, making sure not to walk over previously cleaned areas. 3. Fill the measuring cap 31/2 times with Vax AAA Carpet Cleaner and pour into the clean water tank ig.5/3). CHECK FOR COLOUR FASTNESS: Before cleaning carpet, test for colour fastness. Dampen a white cloth with solution. Test on an inconspicuous area. Gently rub the cloth over the area.
Vax V-022 D4 mm.qxd 9/9/05 4:19 PM Page 6 How to Operate/Emptying the Dirty Water Tank 7. Plug the power cord into an electrical outlet. Turn the power switch to on. Turn turn the power off turn the switch into the off position (Fig.5/7). 1. When there is a distinct change in the noise coming from the carpet washer, the tank is full and needs emptying. Grasp the dirty water tank handle and press the dirty water tank release latch (Fig.6/1). Fig.5.7 8.
Vax V-022 D4 mm.qxd 9/9/05 4:19 PM Page 7 Emptying the Dirty Water Tank/Storage 5. Rinse the dirty water tank and filter thoroughly with lukewarm (max 40ºC) water. Allow to air dry fully before replacing them into the cleaner to prevent mildew (Fig.6/5). 8. While making sure the dirty water tank is resting on the base, place the rear of the tank into the base of the cleaner and push down until it clicks into place (Fig.6/8). Empty and rinse the clean water tank after use. Fig.6/5 Fig.
Vax V-022 D4 mm.qxd 9/9/05 4:19 PM Page 8 Brush Removal & Replacement 8. Brush Removal & Replacement 4. Replace floating brushbar (Fig. 8/4). WARNING: To reduce the risk of injury from moving parts, unplug before servicing. Tool Required: Phillips screwdriver IMPORTANT: The plug must be removed from electrical outlet before cleaning or maintaining the carpet washer. Fig.8/4 5. Replace the brush access cover by inserting the end furthest from the brush first.
Vax V-022 D4 mm.qxd 9/9/05 4:19 PM Page 9 Troubleshooting 9. Troubleshooting WARNING: TO REDUCE RISK OF PERSONAL INJURY, UNPLUG CARPET WASHER BEFORE SERVICING PROBLEM: Carpet washer won’t pick-up or low suction Cause: The dirty water tank door is not installed. Solution: Insert the dirty water tank door. Cause: The dirty water tank door is not installed correctly. Solution: Review placing dirty water tank in base of carpet washer. Cause: The dirty water tank is full.
Vax V-022 D4 mm.qxd 9/9/05 4:19 PM Page 10 UK Service & Help/Technical Specification 10. UK Service & Help Vax Care 0870 6061248 Monday-Friday 9.00am to 5.00pm. An answerphone is available out of these hours. Any queries or concerns about using the Vax, call the Vax Careline. Calls are charged at the UK national rate. Please make a note of the serial number and model number of the carpet cleaner before calling. There are over 400 approved Vax Service Agents in the UK.
Vax V-022 D4 mm.qxd 9/9/05 4:19 PM Page 11 This page has been intentionally left blank.
Vax V-022 D4 mm.qxd 9/9/05 4:19 PM Page 12 EEC STATEMENT OF COMPLIANCE Manufacturer/EEC importer: Vax Limited, hereby on our own responsibility, declare that the product V-022 Vax Rapide Spruce is manufactured in compliance with the following Directives: Safety: 73/23/EEC Low Voltage Directive EMC: 89/336/EEC Electromagnetic Compatibility Directive Waste electrical products should not be disposed of with household waste. Please recycle where facilities exist.
