Owner`s manual

Table 1–12 (Cont.): Standard Console Error Messages

Error Message Meaning

?8029 Bootstrap failed due to previous error.

The previous attempt to bootstrap the sys-

tem failed.

?802A Restart failed due to previous error.

The previous attempt to restart the sys-

tem failed.

Node n: ?xxxx Error message ?xxxx was generatedon sec-

ondary processor n and was passed

to the primary processor to be dis-

played.

No numbered preﬁx appears with these messages in English language mode. These num-

bers are used for these messages in International mode.

Boot and Status Error Messages

The following lists show the status and error messages for Ethernet MOP,

disk, tape, andCI boots. Status messages are shown in the order they would

appear after the boot command is issued. Listed after each status message

are the error messages that could appear during each boot subprocess.

Ethernet MOP Boot Status and Error Messages

1. [Start boot]

?0046 Speciﬁed node is not an I/O adapter

?0100 Speciﬁed adapter failed selftest

?010B Illegal adapter speciﬁed for NI boot

2. * Initializing adapter

?0119 Failure to initialize speciﬁed adapter

3. * Speciﬁed adapter initialized successfully

4. * "Request Program" MOP message sent—waiting for service from

remote node

?0115 Aborting boot process—adapter failed attempting to execute

port command

?0113 No trafﬁc was detected on the net—aborting boot procedure

5. * Still waiting for assistance—reissuing "Request Program" message

Console Operation 1–21