Owner`s manual

Table 1–12 (Cont.): Standard Console Error Messages
Error Message Meaning
?0073 System serial number updated. The EEPROM has been updated with the
correct system serial number.
?0074 System serial number not updated. The EEPROM has not been changed.
?0075 /CONSOLE_LIMIT value too small for
proper operation. Value ignored.
No change has been made.
?0076 Error writing to tape. Tape may be
write-locked.
Tape has not been written. Check to see
if tape is write-locked.
?0077 CCA not accessible or corrupted. Attempt to find the console communi-
cations area (CCA) failed. The con-
sole then builds a local CCA, which does
not allow for interprocessor communica-
tion.
?0078 Vector module configuration error at node
n
The console detected a vector module con-
figuration error. Problem can be that the
vector node number is not one greater
than the scalar CPU or that the mod-
ule to the left of a vector proces-
sor is not a memory module.
?0079 Vector synchronization error. The console could not synchronize with
the vector processor on a console en-
try. The Busy bit in the Vector Pro-
cessor Status Register remained set af-
ter a timeout, or a vector processor er-
ror occurred.
?007A No vector module associated with CPU
at specified node.
No vector module is in the slot to the left
of the specified CPU, or the VIB cable ei-
ther is not attached or is bad.
?007B An error occurred while accessing the vec-
tor module.
Attempt to access VCR, VLR, or VMR reg-
isters failed.
?007C I/O adapter configuration error at node
n
The I/O adapterat node n is configured im-
properly.
?007D Vector module is disabled—check KA64A
revision at XMI node n
The vector module is attached to a KA64A
module that is not at the revision level re-
quired.
?0104 Filename format error. Period and semicolon characters are im-
properly used within the filename speci-
fied for a MOP boot.
?0105 Illegal character(s) in filename. For filename specified in a MOP boot.
Console Operation 1–19