Owner`s manual

Table 1–12 (Cont.): Standard Console Error Messages
Error Message Meaning
?0048 Uncorrectable memory errors—long mem-
ory test must be performed.
A Model 400 memory array contains
an unrecoverable error. The con-
sole must perform a slow test to lo-
cate all the failing locations.
?0049 Memory cannot be initialized. The specified operation was attempted
and prevented.
?004A Memories not interleaved due to
uncorrectable errors:
The listed arrays would normally have
been interleaved (by default or explicit re-
quest). Because one or more of them con-
tained unrecoverable errors, this inter-
leave set will not be constructed.
?004B Internal logic error in console. The console encountered a theoreti-
cally impossible condition.
?004C Invalid node for Z command. The target of a Z command must be a CPU
or an I/O adapter and must not be the pri-
mary processor.
?004D Invalid node for new primary. The SET CPU command failed when at-
tempting to make the specified node the
primary processor.
?004E Specified node is not a processor. The specified node is not a processor, as re-
quired by the command.
?004F System serial number has not been
initialized.
No CPU in the system contains a valid
system serial number.
?0050 System serial number not initialized on
primary processor.
The primary processor has an uninitial-
ized system serial number. All other pro-
cessors in the system contain a valid se-
rial number.
?0051 Secondary processor returned bad
response message.
A secondary processor returned an un-
intelligible response to a request made
by the console on the primary proces-
sor.
?0052 ROM revision mismatch. Secondary
processor has revision x.xx.
The revision of console ROM of a sec-
ondary processor does not match that of
the primary.
?0053 EEPROM header is corrupted. The EEPROM header has been cor-
rupted. The EEPROM must be re-
stored from the TK tape drive.
1–16 VAX 6000 Model 500 Mini-Reference