Owner`s manual

ManualsBrandsVax ManualsHousehold AppliancesX-003B

Table 1–12 (Cont.): Standard Console Error Messages

Error Message Meaning

?002D For Secondary Processor n. This message is a preface to sec-

ond message describing some error re-

lated to a secondary processor. This mes-

sage indicates which secondary proces-

sor is involved.

?002E Speciﬁed node is not an I/O adapter. The referenced node is incapable of per-

forming I/O or did not pass its self-

test.

?0030 Write to Z command target has timed out. The target node of the Z command is not

responding.

?0031 Z connection terminated by ^P. A CTRL/P was typed on the key-

board to terminate a Z command.

?0032 Your node is already part of a Z

connection.

You cannot issue a Z command while exe-

cuting a Z command.

?0033 Z connection successfully started. You have requested a Z connection to a

valid node.

?0034 Speciﬁed target already has a Z

connection.

The target node was the target of a previ-

ous Z connection that was improperly ter-

minated. Reset the system to clear this

condition.

?0036 Command too long. The command length exceeds 80 charac-

ters.

?0037 Explicit interleave list is bad.

Conﬁguring all arrays uninterleaved.

The list of memory arrays for ex-

plicit interleave includes no nodes that

are actually memory arrays. All ar-

rays found in the system are conﬁg-

ured.

?0039 Console patches are not usable. The console patch area in EEPROM

is corrupted or contains a patch revi-

sion that is incompatible with the con-

sole ROM.

?003B Error encountered during I/O

operation.

An I/O adapter returned an error status

while the console boot primitive was per-

forming I/O.

?003C Secondary processor not in console mode. The primary processor console needed to

communicate with a secondary proces-

sor, but the secondary processor was not

in console mode. STOP the node or re-

set the system to clear this condi-

tion.

1–14 VAX 6000 Model 500 Mini-Reference