Technical data

4. Insert the T-connector into the ThinWire connector on the module as
shown in Figure 25. Push in and turn the T-connector clockwise until
it locks in place.
5. Use the cable clamp shipped with the module to form the upper cable
in a loop approximately 10 centimeters (4 inches) in diameter as shown
in Figure 26.
Figure 26: Forming the Upper Cable in a Loop at the DESQA Module
Cable Clamp
MLO-004020
Recommended
Diameter Is
10 Centimeters (4 Inches)
6. Connect the ThinWire cable to one of the following devices.
• A ThinWire Ethernet Multiport Repeater (DEMPR), which can in
turn be connected to a baseband Ethernet cable, and which can
connect up to eight ThinWire segments in a local area network
• A ThinWire Ethernet Singleport Repeater (DESPR), which can in
turn be connected to a baseband Ethernet cable, and connects to
one ThinWire segment
• A ThinWire Ethernet adapter in another system or workstation
NOTE: Contact your network manager or Digital service representative if
you have questions about network configurations.
VAX 4000 Model 300 Installation 41