Technical data

2. Remove the terminator from the bottom of the T-connector shown in
Figure 21. Push in and turn it counterclockwise until it unlocks.
Figure 21: Making a ThinWire Ethernet Connection at the Console
Module
Feed Cable Under System
and Through Opening
T-Connector
ThinWire
Terminator
MLO-006036
3. Make sure the T-connector is inserted into the ThinWire connector.
Turn the T-connector clockwise to make sure it is locked.
4. Connect the ThinWire cable to the T-connector as shown in Figure 21.
• If your system requires one connection to the network:
a. Connect the ThinWire cable to the lower end of the T-connector.
b. Verify that a terminator is connected to the other end of the
T-connector.
Push in and turn the connector or terminator clockwise until it locks
in place.
34 VAX 4000 Model 300 Installation