Technical data

2. Check the settings on each RF-series Integrated Storage Element (ISE).

One is shown in Figure 7.

• Write-Protect button — Make sure that button is in the out (write-

enabled) position.

• Run/Ready button — Make sure that button is in the in (ready)

position.

Verify that a bus node ID plug is inserted into each ISE.

3. Check the setting of the Halt button on the system control panel shown

in Figure 7. It should be in the out (run) position.

4. Check the settings on the console module shown in Figure 7.

• Power-Up Mode switch — Set that switch to the Language Inquiry

mode (uppermost position, indicated by a human proﬁle).

• Baud Rate Select switch — You should have set the console terminal

baud rate to your preference. Set the system to the same rate.

• Break Enable/Disable switch — Set that switch to break enabled

(up, indicated by a 1).

10 VAX 4000 Model 300 Installation