Technical data

5. Connect the ground lead as shown in Figure 5.
a. Loosen the ground screw, above the modular jack.
b. Slide the end of the lead under the screw.
c. Tighten the screw.
You are now ready to set the controls on your system.
6 Set the System Controls
The system controls are on the power supply, Integrated Storage Elements,
system control panel, console module, and tape drives.
1. Check the setting of the Power switch on the power supply shown in
Figure 6. It should be off (set at 0).
Figure 6: System Controls and Indicators — Power Switch
Power Switch
MLO-004263
VAX 4000 Model 300 Installation 9