Technical data

3 Position the System
You can move your system into position in one of two ways as shown in
Figure 2.
• Roll it sideways.
• Slide or walk it backward or forward by gripping the hand holds on the
side of the unit.
WARNING: Do not use the hand holds to lift the system.
Figure 2: Sliding the System into Position
Slides Front
to Back
Rolls Left to Right
MLO-004012
Hand Holds
Leave space behind the system for routing cables. Once installation is
complete, you can place the system directly against a wall. Its oversized
base ensures enough space for proper rear ventilation.
4 VAX 4000 Model 300 Installation