Vax careline 0870 6061248 Vax model number: VZL-901 WARNING: This cleaner has a constantly rotating brush bar which, when left in contact with lino, parquet and other hard flooring could potentially cause some damage to the floor surface. ! NOTE: Vax recommends that you raise the height of the brush bar when using this cleaner on lino and hard flooring. Vax cannot be held responsible for damage to these surfaces if the customer fails to take notice of this recommendation. www.vax.co.
www.vax.co.uk 1. Diagram VZL-901 1 16 2 3 4 17 5 18 19 20 15 6 21 7 22 23 8 12 9 13 14 24 10 25 11 Fig.
Vax Careline 0870 606 1248 2. Safety Information 15. Do not vacuum up hard or sharp objects such as glass, nails, screws, coins, etc. For Household Use Only 16. Do not use without the filters in place. When using the vacuum cleaner, basic safety precautions should always be observed, including the following: 17. Take extra care when vacuuming on stairs. 1. Only use the vacuum cleaner indoors on dry surfaces. 19. Store the vacuum cleaner indoors in a cool, dry area. 2.
www.vax.co.uk 3. How to Assemble Attaching the Upper Hose Holder IMPORTANT: Always remove the power plug from the electrical outlet before assembling or removing accessories. ! Place the upper hose holder into the slot in the back of the vacuum. Using a Philips screwdriver and the screw provided, attach the hose clip to the vacuum (Fig.3/4).
Vax Careline 0870 606 1248 Fig.4/1 Use the upholstery brush to remove dust and pet hair from furniture. Use the dusting brush to dust furniture, Venetian blinds, books, lamp shades and shelves. Attaching the Accessories The accessories can be attached either the handle or to the telescopic wand. To attach the accessories to the handle: Fig.
www.vax.co.uk WARNING: Avoid tipping the vacuum or setting it on furniture, fringed area rugs or carpeted stairs while you are using the hose with the attachments. When the vacuum is turned on, the brush bar will continue to rotate until you put the carpet-to-floor selector to the “Bare Floor/Tools” position. Avoid leaving the vacuum in one place for an extended period of time, particularly on thick carpet.
Vax Careline 0870 606 1248 5. Dirt Container & Filters: Removal & Replacement Removing the Dust Cup Assembly CAUTION: Always unplug the unit from the electrical outlet before removing and emptying the dust cup. Failure to do so, may result in electric shock or personal injury. ! To ensure that your vacuum continues to clean thoroughly, the dust cup should be emptied after each use and/or each time it reaches the “MAX” fill line.
www.vax.co.uk ! Fig.5/6 Make sure that the dust cup and the cyclone shroud are completely dry before re-assembling. To replace the cyclone shroud, insert the cyclone shroud back into the dust cup. Fit the cyclone shroud back into position and turn clockwise to lock it into position. ! Fig.5/8 Step 2 - Close the cyclonic chamber bottom door and shake the cyclonic chamber thoroughly to remove any dust that has adhered to the cyclones (Fig.5/9).
Vax Careline 0870 606 1248 Filter Indicator Light When the filter indicator light flashes, it means that the dust cup is full, the filters need cleaning or there is a blockage in the air paths. You must empty the dust from the dust cup, clean the cyclone shroud, clean the filters and check the unit for any blockages (Fig.5/11). Fig.5/13 Inside the filter housing are two filters. Filter 1 is a foam filter and Filter 2 is a felt filter.
www.vax.co.uk Replace the filter housing base on to the filter housing. Align the arrows on the filter housing with the arrows on the filter housing base and turn clockwise to lock in place (Fig.5/16). You can wash the HEPA filter by running it under the tap allowing the water to run on the dirty side (Fig.5/19). Align here to close Fig.5/19 Fig.
Vax Careline 0870 606 1248 6. Troubleshooting PROBLEM: Air flow restricted with attachment use. Sound changes. WARNING: To reduce the risk of personal injury, unplug the vacuum cleaner before performing maintenance/troubleshooting checks. Cause: ! Cause: New carpet debris clogging air path. Solution: Remove obstruction. PROBLEM: Vacuum cleaner won't run Cause: Attachment use restricts air flow. Solution: Check attachment. Not properly plugged into electrical outlet. Solution: Plug in securely.
EEC STATEMENT OF COMPLIANCE Manufacturer/EEC importer: Vax Limited, hereby on our own responsibility, declare that the VZL-901 series bagless upright is manufactured in compliance with the following Directives: Safety: 2006/95/EC Low Voltage Directive EMC: 2004/108/EC Electromagnetic Compatibility Directive Waste electrical products should not be disposed of with household waste. Please recycle where facilities exist. Check with your Local Authority or retailer for recycling advice. Vax Ltd.
