User guide

www.vax.co.uk
6
dirt container and filters / clearing blockages
C
leaning the pre-motor filter
NOTE: This is located underneath the dirt container bin.
1. Release the pre-motor filter cover by pulling on the
tab.
2. Lift out the filter unit and separate the filter and
c
ase.
3. The pre-motor filter can be rinsed in warm water
(max 40°C). Allow to air dry for 24 hours before
replacing.
NOTE: Do not use any detergents or boiling water to
wash the filter. Vax recommends this filter should be
checked and cleaned periodically.
4. Return the pre-motor filter and case to the vacuum
cleaner and replace the pre-motor filter cover before
restarting the vacuum cleaner.
Cleaning the Post-motor filter
NOTE:This is located on the rear of the vacuum
cleaner.
1. Release the post-motor filter cover by lifting the tab
and remove the filter by pressing in the two catches.
2. The post-motor filter can be rinsed in warm water
(max 40°C). Allow to air dry for 24 hours before
replacing.
NOTE: Do not use any detergents or boiling water to
wash the filters. Vax recommends washing the filter.
Vax recommends washing the filter every 9-12
months.
3. Replace the post-motor filter and cover before
restarting the vacuum cleaner.
7. Cleaning Blockages
WARNING: To reduce the risk of electric shock,
the power cord must be disconnected before
performing maintenance/troubleshooting checks.
1. Turn the vacuum cleaner off and unplug from the
electrical outlet.
2. The flexible hose can be disconnected from the
vacuum cleaner by turning the hose to the left and
pulling away from the machine. Remove any
blockages found then reconnect the hose securely.
Clearing debris from the TurboTool
Switch the vacuum cleaner off and disconnect the power
plug from the electrical outlet.
Rotate the locking ring 180º (Fig.7/1).
Lift the top cover off and remove any blockage (Fig.7/2).
To re-assemble, ensure that the tabs are engage. Pivot the
lower housing closed and rotate the locking ring 180º
(Fig.7/2).
R
emoving debris from the TurboBrush
The brushbar will stop rotating if it is blocked during
operation by vacuuming up foreign objects, or is strands of
carpet are wrapped around it.
!
!
!
!
LOCKING RING
Fig.7/1
Fig.7/2
TABS
Vax VZL-702U User Guide.qxd 27/9/07 15:59 Page 6