User Guide Vax Careline: AU: 1300 361 505 NZ: 0800 800 900 20L Wet & Dry Vacuum Cleaner Get Cleaning... What’s your Vax’s model number? V X 4 0 What’s your serial number? (Located on the top of the machine) Note these down in case you need them in future. Please keep instructions for further use. vax.com.au vax.co.
Vax Careline: AU: 1300 361 505 NZ: 0800 800 900 vax vax
505 900 Machine Overview 1. 2. 3. 4. 5. 6. 7. Motor housing Tank Flexible hose Extension tubes x3 Crevice attachment Foam filter Dry filter vax.com.au vax.co.nz 8. Paper dust bag 9. Dual function floor tool (dry / liquids accessory) 10. On/off switch 11. Carry handle 12. Accessory holders 13.
General Safety Information This machine is intended for household use only, and NOT for commercial or industrial use. When using the vacuum cleaner, basic safety precautions should always be observed, including the following: 19. 1. o not leave the vacuum cleaner unattended when plugged in. D Unplug it from the socket when not in use. 21. 2. Not to be used as a toy. 3. hildren should be supervised to ensure that they do not play C with the appliance. 23.
05 900 Operation Assembling the vacuum cleaner Place the tank upside down and firmly press the four caster wheels into the base of the tank. Attach the 3 piece wand to the end of the hose and then the dual function floor tool to the end of the wand. vax.com.au vax.co.nz Place the top motor housing cover onto the main tank and secure into position with the retaining clips on each side. Push the flexible hose into the connector and twist slightly clockwise.
Operation SETUP the Cleaner from WET to DRY Vacuuming Empty the tank and dispose of any liquid which may have been picked up in wet mode. Remove the foam filter. Dry off any excess moisture from the float cage. Attach the dry filter beneath the motor housing by pushing it on. (This dry filter must ALWAYS be used in dry vacuuming mode to help provide protection and avoid motor damage).
505 900 Operation SETUP the Cleaner from DRY to WET Vacuuming Empty the tank and dispose of any dirt/dust which may have been picked up previously in dry mode. Remove the dry filter and replace it with the foam filter – this slides over the float cage as shown. Remove dust bag from tank. Place the top motor housing cover onto the main tank and secure into position with the two retaining clips.
Operation SETUP the Blower Function WARNING: Keep bystanders clear from blowing debris (including persons and animals) WARNING: Wear a dust mask and protective eye wear when using blower function . IMPORTANT: Make sure the tank container is empty before using the blower. Remove the hose from the standard hose outlet used for cleaning modes and place it on the blower outlet located at the back of the machine. Remove floor tool and connect the crevice nozzle to hose.
505 900 Maintenance (Keep your Vax as good as new) Storage Before storing away, make sure to empty all contents of tank container. Make sure all parts, tank and filters are dry prior to storing machine. Installing and cleaning the DRY filter NOTE: Unplug machine from the power outlet before performing maintenance. Installing Dry Filter 1. Install the dry filter over the filter cage with the flat end of the filter towards the vacuum power head.
Maintenance (Keep your Vax as good as new) Installing and cleaning the FOAM filter NOTE: Unplug machine from the power outlet before performing maintenance. Installing Foam Filter 1. Follow instructions to remove dry dust filter first before changing to foam filter. 2. Carefully slide foam filter down over the filter cage making sure the whole cage is covered. (fig.1 & 2) Cleaning Foam Filter 3. Carefully remove foam filter. (fig.3) 4.
505 900 FAQ’s WARNING: To reduce the risk of personal injury, unplug the cleaner before performing maintenance/troubleshooting checks. Problem The appliance doesn’t work Cause Solution No power Check the power supply. Functional fault in the power cord, switch, or motor Have the damaged part checked by qualified personnel or replace it. Empty the tank Tank is full of liquid Dust is escaping from the motor cover The dust bag is missing or damaged Put in a dust bag or replace it.
Other Information Vax Service & Help Vax Careline: Australia New Zealand 1300 361 505 0800 800 900 Monday-Friday 8.30am to 5.00pm If you have queries or concerns about using your Vax, call the Vax Careline. Calls are charged at the standard local rate. Please make a note of the serial number and model number of the vacuum cleaner before calling. For the nearest Service Agent, please call the Vax Customer Careline or visit vax.com.
505 900 Notes vax.com.au vax.co.
Notes 13 Vax Careline: AU: 1300 361 505 NZ: 0800 800 900 vax vax
505 900 Notes vax.com.au vax.co.
Distributed by Techtronic Industries Australia Pty. Ltd. 31 Gilby Road, Mt Waverley, VIC 3149, Australia. www.vax.com.au Careline: AU: 1300 361 505 www.vax.co.
