Instruction manual

8
Clearing Blockages from the TurboBrush
1. Switch the vacuum cleaner off and disconnect
the power plug from the wall outlet.
2. To remove a blockage from the TurboBrush, lift the
two catches on either side of the TurboBrush
(Fig.7/4) and lift the top cover.
3. Clear the blockage, return the top cover to its
original setting and close the two catches.
NOTE: Ensure the two latches are correctly positioned
otherwise the Turbobrush will not function correctly.
Clearing Blockages from the Hose
1. The flexible hose can be disconnected from the
extending hose by pressing down on to the two
clips and pulling away from the connector
(Fig.7/5). Remove any blockages found, then
reconnect the hose securely.
2. The hose can also be disconnected from the
hand grip by pressing the release button as
shown (Fig.7/6). Remove any blockages found,
then reconnect the hand grip securely.
Clearing Blockages from the Dirt Container
Switch the vacuum cleaner off and disconnect the
power plug from the wall outlet.
1. Lift the dirt container out and empty it.
2. Remove the rubber caps on either side of the
dirt container to remove any blockages found
(Fig.7/7). Then re-insert the rubber caps
securely.
Clearing blockages from the integrated
stretch hose
1. Switch the vacuum cleaner off and disconnect
the power plug from the wall outlet.
2. Remove dirt container.
3. Unscrew dirt container connector (Fig.7/8).
4. Pull the integrated stretch hose out of the main
body of the vacuum cleaner to remove any
NOTE: Ensure the hose is firmly replaced into the
main body of the vacuum before screwing down
the dirt container connector.
Fig.7/7
Fig.7/8
Maintenance
Fig.7/4
Fig.7/5
Fig.7/6
Fig.7/9
2548 VX 2/5 U/G diags 16/12/05 1:49 pm Page 8
blockages. Unscrew the hose connector for
easy
access (Fig.7/9).