Instruction manual

5
2. Fit the telescopic tubes to the hand grip by
pushing the tubes into the hand grip (Fig.3/2).
3. Extend the telescopic tubes by sliding the
collar in the direction of the ridged arrows and
pull the inner tube downwards.
4. Fit the TurboBrush on to the telescopic tubes by
pushing the tubes into the floor tool. Adjust the
tubes to the desired length.
5. Once all of the attachments are in place,
unwind the cable fully and insert the plug into a
wall outlet.
Power Indicator
The power indicator illuminates when the vacuum
cleaner is connected to the mains.
Using the Vacuum Cleaner
1. Insert the power plug into the wall outlet.
2. Press the power on/off button located on the
unit to turn on the vacuum cleaner (Fig.3/3).
Press the button again to turn off the vacuum
cleaner.
3. Press the remote on/off button on the handle
(Fig.3/4).
TurboBrush & Hard Floor Tool
The TurboBrush can be used for carpets and rugs
(Fig.3/5). A hard floor tool is also provided for hard
floors, tiles, parquet, etc (Fig.3/6).
Cord Rewind
To rewind the power cord, press the cord rewind
button with one hand and guide the power cord with
the other hand. This will prevent the cord whipping,
which could cause damage or injury (Fig.3/7).
Remote On/off Button
When the main on/off switch on the body of the
cleaner is on, the vacuum cleaner can be controlled
remotely by the on/off switch on the hand grip.
Press once to turn the vacuum cleaner on, then
press again to turn the cleaner off (Fig.3/8).
If the remote on/off button fails to work, check that
the cleaner is switched ‘on’ on the main body. If the
remote button still fails to work, insert two (2) new
AAA batteries into the hand grip (Fig.3/9).
U
se & Function
Fig.3/7
Fig.3/2
Fig.3/5
Fig.3/6
Fig.3/8
Fig.3/9
Fig.3/3
Fig.3/4
A
2548 VX 2/5 U/G diags 16/12/05 1:49 pm Page 5