2548 VX 2/5 U/G diags 16/12/05 1:49 pm Page 1 Vax Careline: 0870 6061248 www.vax.co.uk BAGLESS CYLINDER VACUUM CLEANER Vax VX2 Instruction Manual Please read carefully before using the cleaner. Always fully extend the mains cable before use.
548 VX 2/5 U/G diags 16/12/05 1:49 pm Page 2 Parts Overview 1. Diagram 3 2 4 1 5 10 14 13 12 9 8 11 6 7 Fig.
2548 VX 2/5 U/G diags 16/12/05 1:49 pm Page 3 Parts Overview Accessories 8 16 15 7 Fig.1/2 17 18 Fig.
2548 VX 2/5 U/G diags 16/12/05 1:49 pm Page 4 Safety Information / Use & Function 2. Safety Information FOR HOUSEHOLD USE ONLY When using the vacuum cleaner, basic safety precautions should always be observed, including the following: 1. Only use the vacuum cleaner indoors on dry surfaces. 2. Turn off the vacuum cleaner controls before connecting to or disconnecting from the mains supply. 3. Always unplug the vacuum cleaner before connecting or disconnecting the vacuum hose. 4.
2548 VX 2/5 U/G diags 16/12/05 1:49 pm Page 5 Use & Function 2. Fit the telescopic tubes to the hand grip by pushing the tubes into the hand grip (Fig.3/2). floors, tiles, parquet, etc (Fig.3/6). A Fig.3/2 3. Extend the telescopic tubes by sliding the collar in the direction of the ridged arrows and pull the inner tube downwards. 4. Fit the TurboBrush on to the telescopic tubes by pushing the tubes into the floor tool. Adjust the tubes to the desired length. Fig.3/5 Fig.
2548 VX 2/5 U/G diags 16/12/05 1:49 pm Page 6 Use & Function / Accessories/ Emptying the Dirt Container Carrying the Vacuum Cleaner NOTE: Ensure the dirt container is securely in place before lifting the vacuum cleaner. The vacuum cleaner can be stood in an upright position for carrying and storage. On the underside of the cleaner is a hook where the floor tool can be parked. When in position, the vacuum cleaner can be lifted up and carried by the carry handle (Fig.3/10).
2548 VX 2/5 U/G diags 16/12/05 1:49 pm Page 7 Filters / Maintenance 6. Maintenance Changing or Cleaning the Pre-Motor Filter 1. Switch the vacuum cleaner off and disconnect the power plug from the wall outlet. Clearing Blockages from the TurboTool Switch the vacuum cleaner off and disconnect the power plug from the wall outlet. 1. Rotate the locking ring 180o (Fig.7/1). 2. Remove dirt container. 3. Remove the pre-motor filter from its position as shown (Fig.6/1). Fig.7/1 2.
2548 VX 2/5 U/G diags 16/12/05 1:49 pm Page 8 Maintenance Clearing Blockages from the TurboBrush 1. Switch the vacuum cleaner off and disconnect the power plug from the wall outlet. 2. To remove a blockage from the TurboBrush, lift the two catches on either side of the TurboBrush (Fig.7/4) and lift the top cover. Clearing Blockages from the Dirt Container Switch the vacuum cleaner off and disconnect the power plug from the wall outlet. 1. Lift the dirt container out and empty it. 2.
2548 VX 2/5 U/G diags 16/12/05 1:49 pm Page 9 Troubleshooting 8. Troubleshooting PROBLEM: Vacuum cleaner won't run Cause: Power cord not firmly pushed into mains socket, or socket switch is off. Solution: Plug the cord in firmly to the power outlet and turn socket on. Cause: Blown fuse or tripped circuit breaker. Solution: Check fuse/breaker. Replace fuse or re-set breaker. Cause: Thermal cut-out operates. Solution: Switch off vacuum cleaner and unplug from mains socket.
2548 VX 2/5 U/G diags 16/12/05 1:49 pm Page 10 UK Service & Help/Technical Specification 9. UK Service & Help Vax Care 0870 6061248 Monday-Friday. 9.00am to 5.00pm. An answerphone is available out of these hours. Any queries or concerns about using the Vax, call the Vax Careline. Calls are charged at the UK national rate. Please make a note of the serial number and model number of the carpet cleaner before calling. There are over 400 approved Vax Service Agents in the UK.
2548 VX 2/5 U/G diags 16/12/05 1:49 pm Page 11 11
2548 VX 2/5 U/G diags 16/12/05 1:49 pm Page 12 EEC STATEMENT OF COMPLIANCE Manufacturer/EEC importer: Vax Limited, hereby on our own responsibility, declare that the product VX2 is manufactured in compliance with the following: Safety: 73/23/EEC Low Voltage Directive, as modified by 93/68/EEC EMC: 89/336/EEC Electromagnetic Compatibility Directive, as modified by 93/68/EEC Waste electrical products should not be disposed of with household waste. Please recycle where facilities exist.
