User guide

7
usage
6. Usage
Plug cord into electrical socket. Turn on the machine by
using the on/off switch located on the side of the machine.
IMPORTANT: Never leave unit unattended with
power on. Turn off when emptying and filling
tanks. Do not saturate the carpet
Step onto unit recline pedal to put the machine into
cleaning position (Fig.6/1).
For the best results, press the solution spray trigger and
push the carpet washer in a forward motion. Release the
trigger and pull the unit backwards in the same path to
agitate and remove dirty water and solution from the
carpet. (For more heavily soiled areas, repeat if
necessary.)
IMPORTANT: For best cleaning results use a
steady, moderate, forward and backward
motion. Always work from back to front across the
room to avoid stepping on wet carpet and lowering
the pile.
When dirty water tank is full, lift dirty water tank latch
and remove from base unit using the handle (Fig.6/2).
Twist dirty water tank outlet cap to the left and remove,
empty, rinse and replace (Fig.6/3).
When cleaning has finished remove the dirty water tank,
rinse with warm water and allow it to dry before storage.
Also remove filter (as shown) rinse with warm water (max
40˚C) and allow it to dry thoroughly before storing.
IMPORTANT: Do not use any chemicals when
cleaning.
NOTE: Do not store cleaner with solution in clean
water tank or dirty water in dirty water tank. Mineral
deposits and mildew can form with will affect the
performance of the carpet washer.
!
!
!
!
Fig.6/2
Fig.6/3
Fig.6/4
Fig.6/1
Fig.6/5
Fig.6/6
Vax Careline: (UK) 0844 412 8455 (ROI) 1-800 928 308
VRS5W Powermax User Guide v1.1.qxd:v1.1 6/9/11 16:14 Page 7