User guide

9
vax.co.uk
Operation
Cleaning the dirty water tank
Lift the front of the carpet cleaner
base off the carpet with one hand.
Grasp the handle and hook the front of
the dirty water cleaner into the base,
making sure that the front of the dirty
water tank is resting on the base.
The dirty water tank has three tabs on
the underside which MUST latch on to
the underside of the base of the
cleaner. The base must be lifted so
that the nozzle is flush with the base
of the cleaner.
Rinse the dirty water tank and filter
thoroughly with warm water. You
should allow them to dry fully
before replacing them on your
cleaner to prevent mildew.
Replacing the dirty water tank
NOTE: Do not use any chemicals in the cleaning process.
NOTE: Failure to install the dirty water tank correctly will result in poor dirty water pick up.
While making sure the dirty water
tank is resting on the base, place the
rear of the tank into the base of the
cleaner, push down on the handle
until it latches Empty and rinse clean
the water tank after use.