User guide

Operation

Grasp the top of the dirty water tank

handle and press the release latch.

Pull the dirty water tank up out of the

base, taking care to ensure that no

dirty water leaks from the front.

Carry Handle

NOTE: Do not transport the carpet washer with either the clean or dirty

water tanks full.

NOTE: If the hose attachment door is not replaced, there will be no

suction through the nozzle and the unit will not operate properly.

Grasp the handle on the back of the

unit to move unit from room to room.

Emptying the dirty water tank

Remove dirty water tank lid.

To empty the water tank grasp the

handle with one hand and the nozzle

with the other and empty into the sink.

NOTE: The float in your machine is the orange piece in the dirty water tank lid, which will shut off the suction when

the dirty water tank is full. For best results, use a smooth steady motion, keeping the nozzle flat against the carpet.

Tipping the cleaner and breaking the seal of the nozzle against the carpet will cause the float to rise cutting off suction.

Once the float is activated, empty the dirty water tank. If the tank does not appear full, turn off the power switch and

wait for the float to settle. For best results use only Vax carpet cleaning solution.

You will hear a distinct change in the noise coming from your carpet washer when the tank is full and needs emptying.

IMPORTANT: Unplug your cleaner before emptying the dirty water tank.