User guide

-
6
Operation
1
2
Remove clean water tank from the
carpet washer.
Unscrew the filler/measure cap from
the rear of the clean water tank. Fill
the bottle cap or measure cap 3
times with Vax carpet cleaning
solution and pour into the tank.
Fill the remainder of the clean water
tank with warm (max 40°C) tap
water. Replace the cap.
Filling the clean water tank
IMPORTANT: Turn off when emptying and filling the clean water tank.
Press on the handle release pedal
and pull the cleaner back into a
reclined position.
While pressing the solution release
trigger, push the cleaner in a
forward motion. Release the trigger
and pull the cleaner backwards over
the same path to remove the dirty
water and solution from the carpet.
Repeat if necessary.
NOTE: Use only Vax carpet cleaning solution, as other cleaning solutions may cause excessive foaming. This may
cause the float to shut off the cleaner prematurely. Using other cleaning solutions will invalidate your guarantee.
Place the bottom of the clean water tank into the cleaner and push into place. There will be an audible click when
the clean water tank is in the correct position.
Plug the cord into a mains
electricity socket. Turn the power
on. The switch is located on the
front of the carpet washer, above
the clean water tank.
Operating the carpet washer
IMPORTANT: Never leave the cleaner unattended with the power on. Vacuum carpets thoroughly with dry vacuum
cleaner before washing. When the dirty water reaches the max fill line on the dirty water tank, empty the tank.