User guide

-
4
Operation
Upper
Cord
Hook
Hose Clip 1
Hose Clip 2
Lower
Cord
Clip
!
1
2
1
2
Assembling your carpet washer
Attach upper handle
Stand the base in the upright
position. Assemble the mid section
onto the base, taking care not to trap
internal mains wire.
Insert the two nuts into the recesses
located on the left and right sides of
the base. While holding the nuts in
place, insert the two medium length
screws through the front of the mid
section and tighten.
Hold the nut in place, insert the long
screw through the front of the
upper handle and tighten.
Align tabs on hose/tool caddy
with slots on midsection and
snap into place.
Place nut into recess on
hose/tool caddy and hold into
place. Press handle release
with your other hand to tilt
the midsection backwards.
Place screw through centre of lower
midsection and tighten.
Hose/Tool Caddy Use
Wrap the cord around the hook
and cord release clips