Operation Manual

Attach both wheels
and push until they click
into place.
Attach the hose connector
to water inlet by turning
clockwise until tight.
Assembling your pressure washer
Preparing your pressure washer for use
Always make sure the pressure washer and water supply are o before connecting or disconnecting the hose
and accessories.
Pushthepressurehosermly
to the water outlet and turn the
pressure hose collar clockwise
until tight.
Whilstrmlypushingthelance
into the trigger handle turn
clockwise to lock into position.
A trigger safety lock is located
underneath the handle. The safety
lock should always be in LOCKED
position before connecting/
disconnecting the pressure hose to
the trigger handle.
To remove the lance from the trigger handle
rmlypushandtwistthelanceanti-clockwise.
When unlocked pull to remove.
Getting started Using your machine
PLEASE READ ‘LET’S TALK SAFETY’ AT THE BEGINNING BEFORE USE
Make sure water supply
is not connected. Firmly
push the water hose pipe
with suitable connector
onto the water inlet to
lock into position.
Connect water hose pipe to
a suitable water supply and
turn water on.
Before plugging the
machine in, press the
unlock safety button
on the trigger handle
and squeeze the trigger
until water starts to ow
through the nozzle.
IMPORTANT: Always use an RCD (Residual Current Device) adaptor when using this pressure washer.
WARNING: Don’t leave the pressure washer running when not in use, or more than 5 minutes to prevent overheating.
Before switching the pressure washer on, the trigger handle must be squeezed to release water and any airlocks in the
machine or pressure hose. Always release any pressure build up in the handle prior to disconnecting the hose.
Connect the power cord
to the mains supply via
an RCD adaptor.
IMPORTANT: Always make sure the trigger safety lock is in the LOCKED position when not in use or connecting
/disconnecting the pressure hose.
Always check water hose, pressure hose, lance and accessories are not damaged broken or worn before use.
To connect pressure hose to trigger
handle, press the pressure hose
release button and push pressure
hose to lock into position. Gently
pull the pressure hose to check
the connection.
Push the ‘I’ switch to turn on.
The machine will run for a
few seconds then stop but no
water will be released.
Squeeze the trigger on the trigger
handle to release a high pressured
water jet, and start cleaning.
Don’t aim the pressure washer
directly at people, animals, plants,
electrical components, wires or the
pressure washer itself.
WARNING
Push ‘O’ switch to turn o.
After connecting
pressure hose, lance and
accessories check they are
securelyttedandlocked
in place before turning on.
Slot the handle in to the top of the
machine and insert the 2 screws.
Turn clockwise to tighten, making
sure not to trap the solution tube.
LOCKED
UNLOCKED