User guide

Vax Service line: AU: 1300 361 505
NZ: 0800 800 900
vax.com.au11
Maintenance
(Keep your Vax as good as new)
Cleaning the Brushes
Push two brush release
buttons (A) and remove
the brush assembly.
The brushes can be washed
with a mild detergent and
rinsed. Do not use a solvent
based detergent.
To replace brushes, align
post (A) on brush block
with hole (B) on bottom of
cleaner. Turn brushes
slightly until post ts easily
into hole. Press brush
assembly rmly to snap
into place.
Return cleaner to upright
position. Replace nozzle,
making sure latches (A)
are out.
The brush assembly can be removed for easy cleaning. Turn cleaner OFF and disconnect from electrical outlet.
Place handle in the upright position. Remove tanks to prevent leaking. Set aside.
Pull the two nozzle release buttons out and remove nozzle as Fig.6/3. Tilt cleaner back so handle rests on oor.
Align middle section of nozzle with opening on cleaner. While holding nozzle in place, slide latches inward to lock
in place. Replace tanks
FIG. 6/8 FIG. 6/10FIG. 6/9