User guide

Vax Service line: AU: 1300 361 505
NZ: 0800 800 900
vax.com.au9
Maintenance
(Keep your Vax as good as new)
Cleaning the Filters
Remove recovery tank
and lid as described on
page 7.
Remove lter lid (A), then
remove lter (B).
Remove loose debris from
lter by tapping the lter
or gently brushing using
your hand. The lter may
also be rinsed for additional
cleaning. Allow lter to air
dry between uses (allow
24hrs to dry completely).
Reposition lter. Replace
lter lid. Press down rmly
until snapped in place.
Dry or loose debris will also
collect on the lter screen
located in the tank lid.
To remove debris from
screen, remove the pleated
lter from the lid. Remove
debris from screen (A).
The lter screen may also
be cleaned by rinsing it
under running water.
Reposition pleated lter in
lid. Replace lid onto
recovery tank, pressing
down rmly until snapped
in place.
To replace recovery tank,
place bottom of tank
behind ledge (A) and push
tank straight into cleaner
body until it is locked
in place.
The tank lid contains a washable, reusable lter. Clean this lter when suction is low or reduced.
Turn cleaner o and disconnect from electrical outlet.
FIG. 6/1 FIG. 6/3FIG. 6/2 FIG. 6/4
IMPORTANT: Even with regular cleaning, lters have a limited lifespan and will eventually need to be
replaced during the lifetime of the hard oor cleaner. If the performance of your hard oor cleaner
is compromised and/or the lters are severely discoloured, the lters may need to be replaced. As a
general guide, Vax recommends lters are replaced every 3-6 months depending on the level of use to
ensure optimum performance of your hard oor cleaner.