User guide

www.vax.com.au 6
Operation
Filling the Solution
(
Upper
)
Tank
Place cleaner handle in
upright, locked position.
To remove tank,
squeeze release
button and pull tank
straight out.
Pour cleaning solution
into tank (A). Fill tank to
fill line (B) with warm
water (Max 40°C).
Carry tank to a sink.
Rotate tank cap
counter-clockwise and
lift up to remove cap (A).
If rubber ring (A) on cap
has become dislodged,
reposition it with uneven
side against ledge (B).
Turn cap (A) upside down to serve
as a measuring cup.
For hard surface floors such as vinyl, linoleum,
marble, laminate wood, polyurethane sealed
wood or other wood floors that can normally
be cleaned using water, use one cup of Vax
cleaning solution.
Replace cap. Rotate
cap clockwise until it
locks in place.
Cap must be locked
in place for proper
performance and to
prevent leaking.
Slide tank straight
into position until latch
snaps in place.
The solution tank holds solution and clean water that is to be dispersed onto the surface being cleaned.
NOTE: Disconnect cleaner from electrical outlet.
IMPORTANT: Check for worn spots or joint separations before using, as these conditions
could lead to damaged flooring when using water to clean floor.
FIG. 4/3
FIG. 4/6
FIG. 4/5
FIG. 4/8
FIG. 4/4
FIG. 4/7 FIG. 4/9