User guide

Vax Service line
AU: 1300 361 505 / NZ: 0800 800 9005
Operation
Transporting
Mode Selector Dial
On/Off Switch
To move your cleaner
from room to room,
put handle in upright
position, tilt cleaner
back on rear wheels
and push forward.
The Mode selector dial
(A) turns the brushes
on and off.
The cleaner may also
be lifted using the
carrying handle (A) on
the front of the cleaner.
Push switch (A) once
to turn cleaner ON.
Push switch again to
turn cleaner OFF.
For dry debris pickup, turn the dial to the DRY
VAC position. In this position, the brushes will not
rotate and are raised off the floor surface.
To wet clean with brushes turned ON, turn the
dial to the WASH position. For wet pickup, turn
the dial to the WET PICKUP position.
Your FloorMate cleaner can be used to both vacuum dry debris and wet clean non-carpeted
floor surfaces such as vinyl, tile and sealed wood. It is not intended for use on carpet or rugs.
CAUTION: To prevent damage to wood floors, follow the flooring
manufacturer’s cleaning recommendations.
NOTE: If using cleaner on sealed wood floors, inspect floor surface for worn finish, bare wood or
separated joints. Do not use the cleaner to wet clean sealed wood floors if any of these conditions exist.
FIG. 3/9
FIG. 4/1
FIG. 3/10
FIG. 4/2
FIG. 3/8