User guide

Vax Service line
AU: 1300 361 505 / NZ: 0800 800 90011
Maintenance
(
Keep your Vax as good as new
)
Cleaning the Brushes
Push two brush
release buttons (A) and
remove the brush
assembly.
The brushes can be
washed with a mild
detergent and rinsed.
Do not use a solvent
based detergent.
To replace brushes,
align post (A) on brush
block with hole (B) on
bottom of cleaner. Turn
brushes slightly until
post fits easily into hole.
Press brush assembly
firmly to snap into place.
Return cleaner to
upright position.
Replace nozzle,
making sure latches
(A) are out.
The brush assembly can be removed for easy cleaning. Turn cleaner OFF and disconnect from
electrical outlet.
Place handle in the upright position. Remove tanks to prevent leaking. Set aside.
Pull the two nozzle release buttons out and remove nozzle as Fig.6/3. Tilt cleaner back so handle
rests on floor.
Align middle section of nozzle with opening on cleaner. While holding nozzle in place, slide latches
inward to lock in place. Replace tanks
FIG. 6/8 FIG. 6/10FIG. 6/9