User guide

Vax Service line
AU: 1300 361 505 / NZ: 0800 800 9009
Maintenance
(
Keep your Vax as good as new
)
Cleaning the Filters
Remove recovery tank
and lid as described in
Section 4.
Remove filter lid (A),
then remove filter (B).
Remove loose debris
from filter by tapping
the filter or gently
brushing using your
hand. The filter may
also be rinsed for
additional cleaning.
Allow filter to air dry
between uses (allow
24hrs to dry completely).
Reposition filter. Replace
filter lid. Press down
firmly until snapped
in place.
Dry or loose debris will
also collect on the filter
screen located in the
tank lid.
To remove debris from
screen, remove the
pleated filter from the
lid. Remove debris
from screen (A). The
filter screen may also
be cleaned by rinsing it
under running water.
Reposition pleated filter
in lid. Replace lid onto
recovery tank, pressing
down firmly until
snapped in place.
To replace recovery
tank, place bottom of
tank behind ledge (A)
and push tank straight
into cleaner body until
it is locked in place.
The tank lid contains a washable, reusable filter. Clean this filter when suction is low or reduced.
Turn cleaner off and disconnect from electrical outlet.
FIG. 6/1 FIG. 6/3FIG. 6/2 FIG. 6/4