User guide

Ethernet controller
After a failure message appears, the testing stops.
Press
Return
to return to the Select Single Device Test menu for more testing.
To exit MDM, press
Break
or the Restart button. For more information, see
Section 2.6.
2.6 Exiting MDM
Exit MDM in one of the following ways:
• Press
Break
.
• Press and then release the Halt button.
Remove the tape cartridge as described in your Operator Information manual.
If you ran MDM on a new system, you are ready to install your software. Set
the write protect button to write-enable and then follow the instructions in
your software manuals.
If you ran MDM on a system containing software, you must reboot that
software.
You can reboot your system software in one of two ways:
• At the console mode prompt ( >>> ), use the command BOOT Dxxx, where
Dxxx is the device name of the fixed disk or RF-series ISE containing your
system software.
Use DUxx for an RA-series disk drive, or an RF-series ISE with a
KFQSA adapter.
Use DIxx for an RF-series ISE with a CPU-based DSSI.
After your system software is loaded, set the Break Enable/Disable switch
to disable (down) to avoid halting the system by pressing
Break
.
• Set the Break Enable/Disable switch to disable (down) and press the
Restart button. That begins the self-test sequence and loads system
software.
Running the Diagnostic Monitor 2–17