User guide

7. Tell your system to load MDM from the disc:
For an internal adapter, enter the command BOOT DKxnnn, where x
is the adapter designator and nnn is the drive unit number.
For a KRQ50 controller, enter the command BOOT/100 DUcu, where c
is the controller designator and u is the drive unit number. Then, when
your system displays Bootfile: , enter [SYS0.SYSEXE]MDMCD.SYS
(the boot file name).
Loading MDM takes several minutes. Section 2.4 describes the display you
see after loading completes.
8. After loading completes, place all hard disks and RF-series ISEs on line.
2.4 MDM Introductory Display
After MDM is loaded, the introductory display appears. Make sure the date
and time in that display are correct.
• If the date and time are correct, press
Return
to continue.
• If the date and time are not correct, type the correct date and time using
the format shown in the display. For example, enter 25–JUN–1994 12:30
and press
Return
to continue.
The Main Menu appears. Section 2.5 describes the options on that menu.
Running the Diagnostic Monitor 2–9