User guide

In the example in this section, the show configuration display shows the
the DZ device has failed. The self-test number for this device is E4. See
Example 1–2. Test E4 should be run by entering T E4 at the console
prompt. If the error remains, show the test results to your Digital Services
representative.
To obtain a listing of the specific tests for the desired device, enter the
command shown in the display.
Example 1–2 Listing Diagnostics
>>>T 9E
Test
# Address Name Parameters
___________________________________________________________________________
20053800 SCB
20054590 De_executive
30 200637BC Memory_Init_Bitmap *** mark_Hard_SBEs ******
31 20064094 Memory_Setup_CSRs **********
32 20064464 NMC_registers **********
33 20064600 NMC_powerup **
34 2005D0A4 SSC_ROM ***
35 20067394 B_Cache_diag_mode bypass_test_mask *********
37 200681C4 Cache_w_Memory bypass_test_mask *********
40 2006242C Memory_count_pages SIMM_set0 SIMM_set1 Soft_errs_allowed *****
41 200579C0 Board_Reset *
42 2005B56C Chk_for_Interrupts **********
46 200670D4 P_Cache_diag_mode bypass_test_mask *********
47 20063D7C Memory_Refresh start_a end incr cont_on_err time_seconds ***
48 20061558 Memory_Addr_shorts start_add end_add * cont_on_err pat2 pat3 ***
4A 200634E0 Memory_ECC_SBEs start_add end_add add_incr cont_on_err ******
4B 20061D78 Memory_Byte_Errors start_add end_add add_incr cont_on_err ******
4C 20062E90 Memory_ECC_Logic start_add end_add add_incr cont_on_err ******
4D 200613BC Memory_Address start_add end_add add_incr cont_on_err ******
4E 20061AF8 Memory_Byte start_add end_add add_incr cont_on_err ******
4F 20062628 Memory_Data start_add end_add add_incr cont_on_err ******
51 2005BA5C FPA **********
52 2005BED8 SSC_Prog_timers which_timer wait_time_us ***
53 2005C1A8 SSC_TOY_Clock repeat_test_250ms_ea Tolerance ***
54 2005B670 Virtual_Mode ********
55 2005C360 Interval_Timer *****
58 200602F0 SHAC_RESET port_number time_secs not_pres
59 2005F584 SGEC_LPBCK_ASSIST time_secs **
5C 2005FAEC SHAC bypass_test_mask *******
5F 2005E870 SGEC loopback_type no_ram_tests ******
(continued on next page)
1–12 Troubleshooting and Diagnosing Problems