User guide

In the example in this section, the show configuration display shows the
the DZ device has failed. The self-test number for this device is E4. See
Example 2–2. Test E4 should be run by entering TE4at the console
prompt. If the error remains, show the test results to your Digital Services
representative.
To obtain a listing of the specific tests for the desired device, enter the
command shown in the display.
Example 2–2 Listing Diagnostics
>>>T9E
Test
# Address Name Parameters
___________________________________________________________________________
20053800 SCB
20054590 De_executive
30 200637BC Memory_Init_Bitmap *** mark_Hard_SBEs ******
31 20064094 Memory_Setup_CSRs **********
32 20064464 NMC_registers **********
33 20064600 NMC_powerup **
34 2005D0A4 SSC_ROM ***
35 20067394 B_Cache_diag_mode bypass_test_mask *********
37 200681C4 Cache_w_Memory bypass_test_mask *********
40 2006242C Memory_count_pages SIMM_set0 SIMM_set1 Soft_errs_allowed *****
41 200579C0 Board_Reset *
42 2005B56C Chk_for_Interrupts **********
46 200670D4 P_Cache_diag_mode bypass_test_mask *********
47 20063D7C Memory_Refresh start_a end incr cont_on_err time_seconds ***
48 20061558 Memory_Addr_shorts start_add end_add * cont_on_err pat2 pat3 ***
4A 200634E0 Memory_ECC_SBEs start_add end_add add_incr cont_on_err ******
4B 20061D78 Memory_Byte_Errors start_add end_add add_incr cont_on_err ******
4C 20062E90 Memory_ECC_Logic start_add end_add add_incr cont_on_err ******
4D 200613BC Memory_Address start_add end_add add_incr cont_on_err ******
4E 20061AF8 Memory_Byte start_add end_add add_incr cont_on_err ******
4F 20062628 Memory_Data start_add end_add add_incr cont_on_err ******
51 2005BA5C FPA **********
52 2005BED8 SSC_Prog_timers which_timer wait_time_us ***
53 2005C1A8 SSC_TOY_Clock repeat_test_250ms_ea Tolerance ***
54 2005B670 Virtual_Mode ********
55 2005C360 Interval_Timer *****
58 200602F0 SHAC_RESET port_number time_secs not_pres
59 2005F584 SGEC_LPBCK_ASSIST time_secs **
5C 2005FAEC SHAC bypass_test_mask *******
5F 2005E870 SGEC loopback_type no_ram_tests ******
(continued on next page)
Diagnostic Tests and Commands 2–5