User guide

General Safety Information
9Vax Careline: (UK) 0844 375 4275
When using the vacuum cleaner, basic safety precautions should always be observed, including the following:
1. Ensure that the unit is disconnected from the mains supply prior to assembling/disassembling any part of
the machine.
2. Do not pull, lift or carry by the cord. Do not close a door on the cord or pull the cord around sharp
edges or corners. Keep the cord away from heated surfaces.
3. This appliance should be used and/or stored in dry environments only.
4. This appliance is not intended for use by persons (including children) with reduced physical, sensory or
mental capabilities, unless they have been given supervision or instruction concerning use of the appliance
by a person responsible for their safety.
5. Use only as described in this manual. Use only the manufacturer’s recommended attachments.
6. Regularly examine the cord for damage, such as cracking or ageing. If damage is found replace the cord
with a genuine Vax part before further use. See p10 for details.
7. Do not use the vacuum cleaner if it has been dropped, damaged, left outdoors, or dropped into water.
Return the vacuum cleaner to a Vax Authorised Service Agent for examination, repair or adjustment.
Call 0844 375 4275 for your nearest service centre.
8. Do not handle the plug or vacuum cleaner with wet hands.
9. Ensure airways remain clear of blockages during use for best performance.
10. Keep hair, loose clothing, ngers and all parts of the body away from openings and moving parts.
11. Do not pick up hot, smoking, burning, ammable, hazardous or combustible materials or use in the
presence of explosive liquids or vapours.
12. Do not vacuum up harmful or toxic material (chlorine bleach, ammonia, drain cleaner, etc).
13. Do not vacuum up hard or sharp objects such as glass, nails, screws, coins, etc.
14. Do not use without the lters in place.
CAUTION: Before plugging the cord in make sure the machine is switched ‘o’ position. Hold the vacuum
cleaner rmly when plugging in and turning on.
PLEASE KEEP THESE INSTRUCTIONS FOR FUTURE REFERENCE.
Motor Thermostat
IMPORTANT: The motor is equipped with a thermal cut-out. If for any reason, the vacuum cleaner should
over-heat; the thermostat will automatically turn the unit o. Should this occur, unplug the vacuum
cleaner, clean the lters and allow the cleaner to cool for approximately one hour. To re-start, plug in the
machine and switch on.
!
!
!
!
!
!
!
!