User guide

Vax Service line: AU: 1300 361 505
NZ: 0800 800 900
vax.com.au7
Maintenance
(Keep your Vax as good as new)
Turn o the vacuum cleaner and unplug it from the electrical outlet.
WARNING: To reduce the risk of injury, the power cord must be disconnected before performing maintenance
or troubleshooting checks.
HEPA Pre-motor filter (Model VCC-07 only)
Clearing blockages
Unclip the retainer clip on
the top of the vacuum
cleaner and lift up to gain
access to the dirt container
department.
The HEPA pre-motor lter
is found in the centre of
the dirt container.
Rotate the lter clockwise
to remove.
Turn vacuum cleaner o and disconnect the power plug
from the electrical outlet.
The exible hose can be disconnected from the vacuum
cleaner by rotating anti-clockwise and pulling away
from the machine. Remove any blockages found then
reconnect the hose.
Gently tap the lter against
the side of the rubbish
bin to remove excess dirt.
The lter may then be
rinsed in cool water.
Allow to thoroughly air
dry before replacing.
Replace the lter every
3-6 months depending on
usage or when the lter
becomes discoloured.
NOTE: Do NOT use any
detergents or boiling water
to wash the lter.
Replace the HEPA lter
back in the machine
before use.
Ensure lter is thoroughly
dry before replacing after
washing.