Operator`s manual

4. Feed the plug end of the cable under the cable management bracket
from the rear of the cabinet and plug it into the KZQSA In connector.
Secure the connection by pressing the bail latches until they snap
into place.
5. Find the KZQSA module and remove the terminator from the upper
connector on that module.
6. Insert the other end of the cable into the connector on the KZQSA
module.
Secure the connection by pressing the bail latches until they snap
into position.
Figure 2–39: KZQSA Cable
MLO-007151
Installation 2–59