Operator`s manual

Figure 2–32: ThinWire Cable, T-Connector, and Terminator
4. Remove the terminator from either end of the T-connector.
5. Connect the ThinWire Ethernet cable to the T-connector as shown in
Figure 2–33.
• If the system requires one connection to the network, connect
the ThinWire cable to the back end of the T-connector and a
terminator to the other end of the T-connector.
Make connections to the T-connector by pushing in and turning
the connector or terminator clockwise until it locks into place.
• If the system is a link in a network and connects to two compo-
nents, connect one ThinWire cable to one end of the T-connector
and connect a second ThinWire cable to the other end.
Connect the cables to the T-connector by pushing in and turning
the connectors clockwise until they lock into place.
Installation 2–51