Operator`s manual

NOTE
Contact your network manager or Digital service repre-
sentative if you have questions concerning network con-
figurations.
When the ThinWire cable is connected to a DEMPR or DESPR, the
ground is provided by the DEMPR or DESPR chassis. If you are using a
single-segment LAN with no DEMPR or DESPR, you may need to ground
the ThinWire connector on the console bulkhead assembly.
CAUTION
Each ThinWire Ethernet segment must have only one
grounding point.
To ground a single-segment ThinWire network at the console bulkhead
assembly, follow the instructions below.
1. Remove the steel nut, the lock washer, and the plastic washer on the
console bulkhead assembly as shown in Figure 2–28.
2. Discard the plastic washer.
3. Replace and tighten the lock washer and the steel nut.
Installation 2–45