Operator`s manual

2.6.5.1 Making a ThinWire Network Connection at the Console Bulkhead
Assembly
Make a ThinWire network connection at the console bulkhead assembly
as follows:
1. Figure 2–25 shows a ThinWire cable, T-connector, and terminator.
Remove the terminator from the back of the T-connector on the Thin-
Wire connector, which is located on the console bulkhead assembly
(see Figure 2–26).
Figure 2–25: ThinWire Cable, T-Connector, and Terminator
2. Connect the ThinWire Ethernet cable to the T-connector as shown in
Figure 2–26.
• If the system requires one connection to the network, connect the
ThinWire cable to the back end (rear most) of the T-connector.
Connect the cable to the T-connector by pushing in and turning
the connector clockwise until it locks into place.
• If the system is a link in a network and connects to two compo-
nents, remove both terminators and connect one ThinWire cable
to each end of the T-connector.
2–42 Installation