Operator`s manual

• If a TLZ-series tape drive is installed in your system (see Fig-
ure 2–10), verify that a bus node ID plug is inserted into the drive.
Figure 2–10: TLZ-Series Tape Drive
Bus Node
ID Plug
0
MLO-007159
Each RF-series ISE disk drive has its own front panel with controls and
indicators. The write-protect button is on the right side of each front
panel. Make sure the write-protect button is in the out (write-enabled)
position.
The run/ready button is to the left of the write-protect button. Make
sure the run/ready button is in the out position.
Installation 2–21