Operator`s manual

Setting Controls on the Integrated Storage Equipment (ISEs)
Check the settings on each ISE:
• If a TF85 tape drive is installed in your system (see Figure 2–8):
— Make sure that the cartridge insert/release handle is closed
(pushed in).
— Verify that a bus node ID plug is inserted in the drive.
Figure 2–8: TF-Series Tape Drive
To Load
To Unload
Write
Protected
Tape in Use
Use
Cleaning
Tape
Operate
Handle
Unload
TF85
Wait
Light
Open this
Handle
Insert Tape
Close this
Handle
Press Button
Wait
Light
Open this
Handle
Remove Tape
Cartridge Insert/
Release Handle
Bus Node
ID Plug
MLO-007171
Installation 2–19