Operator`s manual

2.5 Setting System Controls
The system controls are on the console bulkhead assembly, the system
control panel (SCP), and on each mass storage device. The console
bulkhead assembly contains the power-up mode switch, the baud rate
select switch, and the break enable/disable switch. The SCP contains
the Halt button and Restart button. The mass storage devices include
the RF-series integrated storage equipment (ISEs) and the tape drive.
Each ISE has a write-protect button and a run/ready button.
The SCP and ISE controls are on the front of the system (see Figure 2–7).
The console bulkhead assembly is mounted on the card cage.
Installation 2–17