Operator`s manual

2.4.4 Installing the Cable Management Bracket
Perform the steps in the following procedure to install the cable man-
agement bracket (see Figure 2–6):
1. From the rear of the cabinet, position the cable management bracket
at the top of the fan exhaust grill at the rear of the chassis.
NOTE
The hardware for attaching the cable management
bracket is in the hardware kit (P/N 70-28616-01).
2. Secure the cable management bracket to the chassis with two 6-32
x 5/16 inch screws.
2.4.5 Installing the Cable Tie Bracket
Perform the steps in the following procedure to install the cable tie
bracket (see Figure 2–6):
1. Determine where the cable tie bracket is to be positioned (near the
cable management bracket) at the rear of the cabinet.
NOTE
The hardware for attaching the cable tie bracket is
located in the hardware kit (P/N 70-28616-01).
2. Install four 10-32 U-nuts over the mounting holes in the rear rails
of the cabinet, positioned just above the edge of the chassis, in line
with the cable management bracket (see Figure 2–6).
3. Position the cable tie bracket over the four U-nuts.
4. Secure the cable tie bracket to the cabinet with four 10-32 x 1/2 inch
screws.
Installation 2–15