Operator`s manual

2.4.3 Mounting Chassis on Equipment Slides
Perform the steps in the following procedure to install the chassis onto
the equipment slides:
WARNING
Use sufficient personnel and proper equipment when
lifting or moving the Rack-Mountable VAX 4000 Model
500 computer system. The fully loaded system weighs
53.5 kg (118 lb).
WARNING
Before installing the chassis into the cabinet, ensure
that the stabilizer foot, located at the lower front of the
cabinet, is extended in the fully deployed position.
1. Pull both equipment slides to the fully extended position. Ensure
that both slides are locked in the extended position.
2. Lift the chassis and position it so that the two studs, in the two
forward chassis mounting brackets, are aligned directly over the
forward holes in each of the two equipment slides (see Figure 2–5).
3. Position the two studs in the two rear chassis mounting brackets
directly over the rear slots in each of the two equipment slides (see
Figure 2–5).
4. Lower the chassis onto the equipment slides.
5. Secure the VAX 4000 chassis to the slides using eight 10-32 KEP nuts
with lockwashers over the eight studs and tighten, using a 3/8-inch
socket wrench.
6. Push the slide locks up (see Figure 2–2) and slide the chassis into
the cabinet.
7. To securethe VAX 4000 to the cabinet, tighten the four captive screws
mounted on the bezel.
2–14 Installation