Operator`s manual

20. Position the right-hand slide (see Figure 2–3) and secure it in two
places, front and rear. Torque the 1/4-20 screws to 60-in-lb.
NOTE
Pull the slide upward when securing it to the rails.
Also, ensure that the slide is level and that the slides
are at the same height within the cabinet.
21. Repeat step 19 for mounting the left-hand slide in the cabinet.
22. Extend the equipment slide all the way out and tighten the four
screws holding the rear (one CR and one CL) slide mounting brackets.
23. Install four U-nuts #1 and #2 (cabinet clips) two places each (see
Figure 2-3). These are for securing the VAX 4000 bezel in the closed
position.
2–10 Installation