Operator`s manual

7. Position the CL bracket to the outside of the right hand chassis slide
so that the end hole, on the chassis slide, is in line with the rear slot
of the CL bracket (see Figure 2–2).
8. Install an 8-32 x 5/16-inch screw, flat washer, split washer and nut
in the rear slot of the CL bracket. Install the screw from the inside
of the slide. Do not tighten the screw at this time (see Figure 2–2).
9. Install an 8-32 x 5/16-inch screw, flat washer, split washer and nut
in the center slot of the CL bracket. Install the screw from the inside
of the slide. Do not tighten the screw at this time (see Figure 2–2).
10. Extend the left-hand slide to gain access to the slide lock. Lift up on
the slide lock (located on the inside of the left-hand slide assembly),
remove the slide (see Figure 2–2) and set it aside.
11. Position the CL bracket to the outside of the left hand chassis slide
so that it is flush with the front end of the chassis slide.
12. Align the screw hole in the CL bracket over the single forward screw
hole in the forward end of the equipment slide (see Figure 2–2).
13. Secure the CL bracket to the front end of the right chassis slide using
an 8-32 x 5/16-inch screw, flat washer, split ring lock washer and
nut. Insert the screw from the inside of the slide. Use a nut driver
to tighten the nut on the outside of the CR bracket (see Figure 2–2).
14. Install an 8-32 x 5/16-inch screw, flat washer, split ring lock washer
and nut in the center slot in the CL bracket. Insert the screw from
the inside of the slide. Use a nut driver to tighten the nut on the
outside of the CR bracket (see Figure 2–2).
15. Position the CR bracket to the outside of the right-hand chassis slide
so that the end hole, on the chassis of the slide, is in line with the
rear slot of the CR bracket (see Figure 2–2).
16. Install an 8-32 x 5/16-inch screw, flat washer, split washer and nut
in the rear slot of the CR bracket. Install the screw from the inside
of the slide. Do not tighten the screw at this time (see Figure 2–2).
17. Install an 8-32 x 5/16-inch screw, flat washer, split washer and nut
in the center slot of the CR bracket. Install the screw from the inside
of the slide. Do not tighten the screw at this time (see Figure 2–2).
Installation 2–7